Furnace Blowing Cold Air in Gary, IN
Call (219) 501-8050 for Dispatch
What Furnace Blowing Cold Air Involves
Technicians trace why the burners are off while the blower runs: checking limit-switch continuity, measuring static air pressure across the filter and coil, testing the flame sensor microamp signal, and inspecting the control board relay.
Common Warning Signs to Watch For
- Registers blow cool room-temperature air continuously
- Air starts warm for 2–3 minutes and then turns cold
- Blower fan never shuts off even when the thermostat is satisfied
- Furnace cabinet feels abnormally hot before the burners cut out
- Blinking diagnostic LED code visible through the blower door sight glass
Cost Factors in Gary & Lake County
If the issue is a dirty filter or thermostat setting, no part replacement is needed. Mechanical causes range from inexpensive flame-sensor or limit-switch replacements to higher-cost control board repairs. You can preview typical local ranges anytime with our interactive cost calculator or read our Gary furnace repair cost guide.
Related Services & Neighborhood Coverage
Before calling, review our step-by-step cold air troubleshooting article. If the burners never light at all, visit igniter and pilot repair, or if the fan itself makes noise or stalls, see blower motor repair. We dispatch across Miller Beach and Glen Park from our Gary furnace repair homepage.
Frequently Asked Questions
This pattern usually points to overheating: restricted airflow from a dirty filter or closed vents trips the high-limit switch, shutting off the burners while the blower keeps running to cool the heat exchanger.
Yes. If the thermostat fan switch is set to ON rather than AUTO, the blower runs 24/7 even between heating cycles, circulating unheated air through the ducts.
Most sensor, limit-switch, and ignition-related cold-air repairs are completed in a single visit once diagnosed by an independent technician.